Using the probe compensation signal, Measurement, X1 x10 – GW Instek GDS-1000 Series User Manual User Manual
Page 41

MEASUREMENT
41
Stop
mode
In Stop mode, the vertical scale
setting can be changed but the
waveform shape stays the same.
Using the probe compensation signal
Background
This section introduces how to use
the probe compensation signal for
general usage, in case the DUT
signal is not available or to get a
second signal for comparison. For
probe compensation details, see
page94.
Note that the frequency accuracy and duty factor
are not guaranteed. Therefore the signal should
not be used for reference purpose.
Waveform type
Square waveform used for probe
compensation. 1k ~ 100kHz, 5% ~
95%.
Demonstration signal for showing
the effects of peak detection. See
page52 for peak detection mode
details.
View the probe
compensation
waveform
1. Connect the probe between the compensation
signal output and Channel input.
VOLTS/DIV
VOLTS/DIV
TIME/DIV
CH 1
MATH
CH 2
MENU
MENU
Acquire
Display
Utility
Help
Run/Stop
VARIABLE
FORCE
Autoset
Cursor
SINGLE
Hardcopy
Measure Save/Recall
LEVEL
VERTICAL
HORIZONTAL
TRIGGER
Digital Storage Oscilloscope
GDS-1042
40MHz 250M Sa/s
CH1
CAT
300V
MW 22pF
MAX. 300Vpk
1
CH2
EXT TRIG
CAT
300V
MW 22pF
MAX. 300Vpk
1
X
Y
X
10
X
1
CH1
x1
x10