GW Instek SPD-3606 - Manual (Page 10)

SETUP
19
S
ETUP
This chapter describes how to properly power up
and configure SPD-3606 before the operation. For
checking the functionality, refer to the
Performance verification chapter, page40.
CH3 CH2 CH1
O.V.P. SET NORMAL
CH2
GND
0 60
V , 3A
0 30
V , 6A
OUTPUT
ON / OFF
Installation Installation Location........................................20
Power Power Up ........................................................21
OVP Over Voltage Protection Set .............................22
Load Wire Load Cable Connection ....................................24
Output Output On/Off ................................................25
SPD-3606 User Manual
20
Installation Location
Ventillation space Leave at least 3cm around SPD-3606, to the left and
right.
Cooling fan
opening The cooling fan is located on the rear panel.
Allocate extra space on the back of SPD-3606 so
that the cooling fan opening would not become
blocked.
Cooling
Fan