GW Instek GDS-2000A series Option User Manual - Manual (Page 75)

LOGIC ANALYZER
75
3. Select Others → Bus from
the side menu. The Bus
indicator appears at the
bottom of the display.
From left: Bus trigger, Data source
4. Press Data from the bottom menu.
5. Press Data from the side menu to
edit the triggering data.
To edit the data, use the Variable
knob to highlight a binary or hex
digit and press Select. Use the
Variable knob to choose a value for
the digit and press Select to
confirm.
VARIABLE
Binary 0,1,X (don’t care)
Hex 0~F, X (don’t care)
6. The bus will now trigger when the specified
data appears on the bus.
Common Bus Trigger Settings
Bus Trigger Mode
Trigger Mode 1. Like the other trigger configurations, the Bus
Trigger mode can be set to Auto (Untriggered
Roll) and Normal.
This applies to the serial and parallel buses.