Triton RT2000 User Manual - Manual (Page 157)

A-3
A
PPENDIX
A - M
ECHANICAL
/E
LECTRONIC
L
OCKS
Changing Index
Opening Index
Changing the Combination
Change the Combination
To change the combination, you will need access to the existing combination and
a change key. First, open the safe door by dialing the existing combination. With
bolt retracted and before changing combination, verify that the dial stopped
between 90 and 100 on the OPENING Index.
Select three new numbers. DO NOT use any number between 1 and 20 for the
last number.
For maximum security, do not use numbers that end in 0 or 5, and do not use
numbers in sequence: e.g., ’27-48-86' is not as good as ’27-86-48". Perform the
following steps next:
1. Dial the existing combination again using the CHANGE Index, but STOP the
dial on the last number of the combination.
2. With the last number set at the changing index, hold the dial securely and
insert the change key in the keyhole in the back of the lock. Make sure the
wing is entirely inside the lock and comes to a positive stop (see Figure 1)
before turning the key.
If the change key will not go in, the wheels are not lined up to be changed
and you must dial the combination again on the Change Index.