Triton RT2000 User Manual - Manual (Page 156)

A-2
M
ODEL
RT2000 U
SER
M
ANUAL
Introduction
The security cabinet can be secured using either a mechanical or electronic
combination lock. This Appendix covers how to change the combination of ei-
ther lock. Procedures specific to the electronic lock, such as changing the bat-
tery, are also covered. The first section covers the Mechanical combination lock.
Operating the Mechanical Lock
Unlocking the Lock
There are two marks on the dial ring (see drawing opposite page). The index at
the top is used for opening the lock, The index 30 degrees to the left is used only
when changing the combination.
The dial should always be turned slowly and evenly. A revolution is counted
each time the selected number is aligned with the opening index. DO NOT TURN
THE DIAL BACK TO COMPENSATE FOR OVER DIALING A NUMBER. If,
when dialing the combination, any number is turned beyond the index, the entire
sequence must be repeated.
Locks are shipped on a factory setting of ‘50’. Using the OPENING Index, to
unlock, turn the dial to the left (counterclockwise) four (4) turns, stopping on
‘50’. Then, turn the dial to the right until the dial stops. The combination lock bolt
will retract and the safe door may be opened.
Unlocking 3-number combinations (For Example, “50-25-50”)
1. Turn the dial to the LEFT at least four (4) complete turns to clear the
combination lock to accept the combination.
2. Using the OPENING Index, turn the dial to the LEFT, stopping when ‘50’ is
aligned with the opening index, the FOURTH time.
2. Turn the dial to the RIGHT, stopping when ‘25’ is aligned with the opening
index, the THIRD time.
3. Turn the dial to the LEFT, stopping when ‘50’ is aligned with the opening
index, the SECOND time.
4. Turn the dial slowly to the RIGHT until the bolt retracts.
Locking the Lock
Turn the dial to the LEFT at least four full revolutions.