Triton RT2000 User Manual - Manual (Page 139)

119
E
RROR
R
ECOVERY
Clearing Terminal Status
In following the error recovery procedures in Table 7-1, in most cases the first action
you will perform will be to clear the error status.
In some cases, if the terminal is reporting an error in a user-serviceable component
area, such as a low receipt paper or currency condition, check the area and replace
the receipt paper, load currency, or other actions as applicable.
After performing the indicated action, you will attempt to clear the error status.
If the error condition continues to be reported, even after performing the action to
clear the error status, then a restart of the terminal may be warranted. A restart action
will re-initialize the terminal’s operating system.
There are a number of procedures available to perform clear or restart actions:
Clear terminal status using Management Functions.
Restart terminal using Management Functions.
Shut down (remove power) using Management Functions.
* Shut down /apply power using Power Supply ON/OFF switch (Use as
last option).
Perform the applicable clear and/or restart action as directed by the error recovery
procedure. The following sections, on pages 121 through 124, describe how to
perform each action.
NOTE: The least disruptive procedure should be tried first. Try to CLEAR the
error status before RESTARTING the terminal.
A
B
C
D