Triton RT2000 User Manual - Manual (Page 134)

114
M
ODEL
RT2000 U
SER
M
ANUAL
12. The blue tension lever is located
on the right side. It must be in the
closed position (Blue lever facing
towards the left) [Figure 6-9 and
insert]. If not, just move the lever
(moves in 3 positions) to the
correct position. Close the cutter
assembly and retry to feed the
printer paper. If successful,
continue with Step 9. If the paper is
not taken up automatically, contact
your service provider.
13. Close and lock the cabinet sleeve
door. Go to Management
Functions, Diagnostics, Printer,
and perform a “Reset/Test Printer”.
Figure 6-8. Release pin location.
10. Grasp the handle below the printer
feed slot (Figure 6-7) and pull the
release pin located on the right side
of the printer bracket ( Figure 6-8).
11. Rotate the assembly up and release
the pin until it locks in place as
shown in Figure 6-9. (This position
also allows receipt access for
printing status if using the
Opersator Service Panel)
Release pin
Figure 6-7. Printer handle.
Figure 6-9. Printer rotated in
Operator Service position.