Triton 9100 User Manual - Manual (Page 76)

68
M
ODEL
9100 U
SER
M
ANUAL
9. Rotate the printer towards the front of the unit (Figure 5-7).
Figure 5-5. Feed paper into the printer take-up slot. Figure 5-6. Thumbscrew location.
7. Feed the end of the paper into the printer take-up slot (Figure 5-5). The printer will activate and
automatically feed the paper through the printer and slightly out the front of the control panel.
8. If the printer does not feed automatically, open the printer assembly by loosening the thumbscrew on
the side as shown in Figure 5-6.
Figure 5-7. Rotate printer open.
10. Check the blue lever to ensure it’s in the correct position as shown in Figure 5-8. If it is not in the
position shown, move the lever (moves in 3 positions) to the correct position. Close the printer
assembly and perform step 7 again.
Figure 5-8. Blue tension lever (correct
position).
11. Close and lock the control panel. Go to M
ANAGEMENT
F
UNCTIONS
> D
IAGNOSTICS
and perform a T
EST
R
ECEIPT
P
RINTER
. If the test receipt is printed successfully, place the ATM back in service.