Triton 9100 User Manual - Manual (Page 63)

55
C
URRENCY
H
ANDLING
Rotate mechanism to “Service” position
(clockwise).
Removing note cassette (TDM-100).
4. To remove the note cassette(s), grasp the cassette
handle and pull in a firm but controlled manner to
release the cassette from the snap catches. Try to
use only the minimum amount of force to release
the cassette! The cassette will only move a few
inches! Once released from the snaps, you can
slide the cassette out of the mechanism. Place the
cassette on a level, flat surface for replenishment.
1. Unlock and open the security cabinet door.
2. (TDM-150/200/250) Extend the dispenser mounting tray fully as shown below. Note: The TDM-
100 uses a fixed-tray mounting system.
3. To gain access to the cassette(s), rotate the mechanism mounting platform to the “Service” position:
!
Locate the spring-loaded locking pin on the underside of the tray.
! Pull the pin down to release the swivel mounting platform.
! Slowly turn the tray clockwise 180° so that the note and reject cassette(s) can be accessed from the
front of the unit.
!
Release the locking pin and move the mounting platform back and forth slightly to ensure the pin
snaps back into place, locking the mounting platform into the service position.
Lift up on slide tray locking levers.
R
EPLENISH
C
ASSETTE
(TDM-100/150/200/250)