Triton 9100 User Manual - Manual (Page 35)

27
M
ANAGEMENT
F
UNCTIONS
2. Password Required - When “Enter Master Keys” is
selected, you will be prompted to enter two (2) pass-
words. If this is an initial setup, the default password
is six (6) zeros (000000) for each. You will then be
prompted to change passwords. Passwords MUST
be changed!
3. Change Password (Initial Setup) - The VEPP requires
that no default password can be entered. If a user
enters the default password, the VEPP will force the
user to change them before they can enter keys.
4. Change User Passwords (cont) - This screen allows
the user(s) to select which password to change. If
any password is the default value, the VEPP will only
allow these two functions to be selected.
5. Change User Passwords (cont) - If this is an initial
setup, the current password will be six (6) zeros
(000000). Enter a new password (twice). A password
consists of six (6) numbers, no characters. A screen
prompt will appear if the passwords was changed
successfully. DO NOT use weak passwords (Ex:
111111,123456)