Triton 9100 User Manual - Manual (Page 25)

17
M
ANAGEMENT
F
UNCTIONS
N
EW OR
M
ODIFIED
M
ANAGEMENT
F
UNCTIONS
The majority of the Management Functions are configured the same as before but they may have been
relocated in the menu structure. A brief synopsis of each function is provided. A summary of the changes
to the Management Functions is provided below:
!
M
AIN
M
ENU
- Three (3) major configuration paths now exist: Terminal, Services, and Processors.
The other options (Cassette Service, Diagnostics, Close, and Journal) have moved slightly but their
functions remain the same.
! D
IAGNOSTICS
- To reset an on-screen VEPP tamper error ‘205’ or VEPP Serial number error ‘239’,
you must traverse through the Diagnostics menu items. A new option, “K
EYPAD
”, allows user to clear
either of these 2 error codes.
!
Key Management - Two (2) passwords are now required before users can enter the PIN Master
keys option. Once accessed, two (2) key parts (32 number/character stream) must be loaded, followed by
a second part. The Check Digits are displayed before either accepting or declining. An on-screen keypad
directs users for entering numbers and characters.
! C
OMMUNICATION
- This menu item replaces the Telephone Configuration. TCP/IP configuration
setup is now included with the Modem setup.
!
T
RITON
C
ONNECT
™ - Moved under “ATM Monitoring”. TCP/IP configuration setup also in-
cluded for Triton Connect. The communication type (dial-up or TCP/IP) is automatically detected.
!
C
ONFIGURE
P
ROCESSORS
- Processor specific information is now configured under this option.
Standard ATM cash transactions WILL use processor number one (1) as its default. Processors 2
through 4 reserved for future applications.
! S
URCHARGE
- You may now block up to one hundred (100) ISOs at the terminal.
! U
PDATING
S
OFTWARE
. When installing an update file over any prior software release on a terminal
with a TDM100 or TDM150 dispenser, the cassette multiple amount (value) will need to be reconfigured
before the terminal will go into service. You will only have to configure one time after you update. Any
other future releases will not require configuring amount values.
Software Updates
There are Supplements at the back of this document that describe new/
changed Management function features. Refer to your particular countries
version for information regarding these updates.
Cassette Service
Multi-Cassette Dispensers: During the initial boot procedure, the terminal may force
an Error Code 156 to ensure the user enters the Cassette Setup functions to configure
and put at least one cassette “In Service”.