Triton 9100 User Manual - Manual (Page 104)

B-2
M
ODEL
9100 U
SER
M
ANUAL
I
NTRODUCTION
The security cabinet can be secured using either a mechanical or electronic combination lock. This
appendix covers how to change the combination of either lock. Procedures specific to the electronic lock,
such as changing the battery, are also covered. The first section covers the Mechanical combination
lock.
O
PERATING THE
M
ECHANICAL
L
OCK
U
NLOCKING THE
L
OCK
There are two marks on the dial ring (see drawing opposite page). The index at the top is used for opening
the lock, The index 30 degrees to the left is used only when changing the combination.
The dial should always be turned slowly and evenly. A revolution is counted each time the selected
number is aligned with the opening index. Do not turn the dial back to compensate for over-dialing a
number. If, when dialing the combination, any number is turned beyond the index, the entire sequence
must be repeated.
Locks are shipped on a factory setting of ‘50’. Using the ‘Opening Index’, to unlock, turn the dial to the
left (counterclockwise) four (4) turns, stopping on ‘50’. Then, turn the dial to the right until the dial stops.
The combination lock bolt will retract and the safe door may be opened.
Unlocking 3-number combinations (For Example, “50-25-50”)
1. Turn the dial to the Left at least four (4) complete turns to clear the combination lock to accept the
combination.
2. Using the ‘Opening Index’, turn the dial to the Left, stopping when ‘50’ is aligned with the opening
index, the Fourth time.
2. Turn the dial to the Right, stopping when ‘25’ is aligned with the opening index, the Third time.
3. Turn the dial to the Left, stopping when ‘50’ is aligned with the opening index, the Second time.
4. Turn the dial slowly to the Right until the bolt retracts.
L
OCKING THE
L
OCK
Turn the dial to the Left at least four full revolutions.