Triton 9100 User Manual - Manual (Page 156)

M
ODEL
9100 U
SER
M
ANUAL
SD-2
N
EW
C
HANGES
The following describes new changes implemented in the latest (Feb, 07) 8100/9100 US software release.
This supplement describes additional features that make up this software. This software release also
pertains to the Model 8100 terminal software, providing a single load file for updating 9100 or 8100
terminals.
1. TDM Support
2. Fully Supports TDM-2XX Return Codes
3. Test Dispense with TDM-2XX Return Code Intact
4. Test for TDM-1XXs before TDM-2XXs
5. Correcting the Screen Flow for the Printer Off-Line Notification
6. Auto Recovery from 139 Printer Error (9100 only)
7. Default Password Detection
TDM S
UPPORT
The Triton 9100 ATM system supports a variety of TDM dispenser mechanisms (TDM-100/150, TDM-
200/250 etc.) with this release. The approach has been to provide a common dispenser-resident firmware
package for all TDM dispensers, making the terminal SW interface common to all types.
For the dual feed channel TDM-2XX dispensers, cassettes A through C are available for configuration.
Cassette D is not supported for any of the TDM dispensers and should appear grayed out on all
Management functions screens. The terminal immediately flags non-resident cassettes as “Out of Ser-
vice” once the SW returns from Management functions to customer transactions for multi-feed channel
mechanisms.
Single feed channel dispensers such as the TDM-50 for the 8100 and TDM-1XX dispensers for the 9100
display only cassette A, all other cassettes will appear grayed out. The cassette type has a default setting
of ‘Cash’. They are automatically placed “In Service” after boot. The “In-Service” configuration and
status items do not apply to single feed channel dispensers. Only the value parameter requires configu-
ration after a full load. TDM-50 dispensers are single “fixed bin” dispensers (no actual cassette). The
terms cassette and bin may be used interchangeably in the scope of this document.
With this and future versions of 9100 software, when installing an update file over any prior software
release on a terminal with a TDM50, TDM100, or TDM150 dispenser, the cassette multiple amount will
need to be reconfigured before the terminal will go into service**.
**Note - In this situation, if an update file is loaded from Triton Connect, the machine can only be put into
service by configuring the cassette multiple amount in Management Functions at the terminal. Subse-
quent update loads will not require this step.