Triton 9100 User Manual - Manual (Page 169)

S
UPPLEMENT
F
SF-3
F
ULLY
S
UPPORTS
TDM-2XX R
ETURN
C
ODES
This release fully supports the TDM-2XX return codes. There are two classes of return codes where one
is a soft error that the terminal will accept and retry the failed command. The second class is a fatal error
and will cause the terminal to not retry and go out of service with the error code.
T
EST
D
ISPENSE WITH
TDM-2XX R
ETURN
C
ODE
I
NTACT
The TDM-2XX reports a status of the test dispense operation. This release corrects the reporting of that
status information.
T
EST FOR
TDM-1XX
S BEFORE
TDM-2XX
S
This release corrects the problem of newer TDM firmware that responds to both command sets of the
TDM product line. These command sets changes the way that cassettes are managed and error codes
that are reported. This release will test for a single cassette TDM before testing for a TDM multi-cassette
mechanism.
A
UTO
R
ECOVERY FROM
139 P
RINTER
E
RROR
(9100
ONLY
)
This maintenance release adds the capability to the terminal to auto-recover from an 139 error if possible.
The 139 error condition indicates that the terminal experienced a problem with the printer. Previous
releases required the Terminal Owner to restart the terminal and then reset the error. Now if the printer
recovers from the error, the terminal will constantly test for this state and automatically reset the error and
return into service. If paper was out when this error occurred, within 30 seconds of paper being reloaded,
the terminal will go back in service.
C
ORRECTING THE
S
CREEN
F
LOW FOR THE
P
RINTER
O
FF
-
LINE
N
OTIFICATION
The Printer off-line notification will now return the customer to the Transaction Cancelled screen then to
the Welcome Screen when the No is selected or the screen exhausts its timeout waiting for input from the
customer.
With this and future versions of 9100 software, when installing an update file over any prior software
release on a terminal with a TDM50, TDM100, or TDM150 dispenser, the cassette multiple amount will
need to be reconfigured before the terminal will go into service**.
**Note - In this situation, if an update file is loaded from Triton Connect, the machine can only be put into
service by configuring the cassette multiple amount in Management Functions at the terminal. Subse-
quent update loads will not require this step.
PIN B
LOCK NOT BEING
C
LEARED BETWEEN
EMV T
RANSACTIONS
The PIN block is now cleared at that beginning of every Transaction including EMV transactions.