Triton 9100 User Manual - Manual (Page 170)

M
ODEL
9100 U
SER
M
ANUAL
SF-4
T
ERMINAL
D
ISPENSES
C
ASH AFTER
R
EMOVE
C
ARD
P
ROMPT
At the end of an EMV Transaction, if the customer does not remove their card when prompted the
terminal cancels the transaction and reverses the transaction with the host.
U
PDATE
L
OAD
F
ILES CAN CAUSE
L
ONG
EMV T
RANSACTION
T
IME
Update files contain a minimum set of default parameters. These files contain the parameter for the Card
reader timeout during EMV data exchanges.
VISA AIDS
Three new VISA AIDs were added to the terminal. They are as follows:
Visa Electron (AID: 0xA0000000032010)
Visa Interlink (AID: 0xA0000000033010)
Visa Plus (AID: 0xA0000000038010)
All VISA AIDs will be defaulted to disabled. This AIDs must be enabled through Management functions
or Triton Connect.
C
ONFIGURABLE
D
ELAY TO WHEN
P
REDIAL
S
TARTS
For locations with faster communication times, this release includes a parameter that adjust the time when
predial starts. The predial delay is set to zero (0) which does not change any timing in both load files.
D
EFAULT
P
ASSWORD
D
ETECTION
The terminal will no longer go into service if the Master and/or Administration passwords are configured
in their default setting. A new error code (246) will be displayed when the passwords are in their default
state. The terminal will detect this condition and go out of service. On the “Out of Service” screen,
no error information will be displayed. The following are screen captures of this state. This error
code will not clear until the Master and/or the Administration passwords are changed from their
default state.