Hired-Hand Evolution 4000 Control System - Manual (Page 50)

Part No. 4801-5338 Rev 01-10 Evolution 4000 50 of 86
Load / Save Instruction Screens
** SD Card Operations **
Save/Load Programs
Load Program from SD Card
Save Program to SD Card
Update Controller Software Version
OR
Save Program to SD Card Load Program from SD Card
Please wait while your SD Card is
accessed.
** Loading Program...
** Load Program Complete.
"
WARNING: The following settings are not
included as part of the program loaded
from the SD card and will need to be
verified.
Date: = 26 Jan 2010
Day = Tue
Time = 1:08p
Vent Anticipation:
Time before fan starts = 1 s
Time after fan starts = 1 s
HHNet Address = 1
The following settings are loaded from
the SD Card but should be reviewed to
ensure that the settings are correct for
your current setup and livestock age.
Any time that you load a program, you
should verify that all settings are
correct.
After you review Sensor Setup, you will
be returned to the Program Setup Screen.
Tunnel Enabled = Off
Backup Enabled = No
Sensor Setup
Please wait while your SD Card is
accessed.
** Saving Program...
Please wait while your SD Card is
accessed.
** Save Complete. 1104 Values Saved
** Press “Enter” to Return.
WARNING: The following settings are not included as part of the program loaded from the SD card and
will need to be verified: Date, Day, Time, Vent Anticipation (Time before fan starts & Time
after fan starts), and HHNet Address.
The following settings are loaded from the SD Card but should be reviewed to ensure that
the settings are correct for your current setup and livestock age: Tunnel Enabled, Backup
Enabled, & Sensor Setup.
Any time that you load a program, you should verify that all settings are correct. After you
review Sensor Setup (Refer to Section 7.3), you will be returned to the Program Setup
Screen (Refer to Section 6.7).
NOTE:
The number of Values Saved is a
number which may vary for different
software versions. Values Saved is
the specific number of settings
copied from the controller.