beautypg.com

Hired-Hand Manual Light Dimmer User Manual

Manual light dimmer, Installation, Operation

background image

MANUAL LIGHT DIMMER

GND

Hot
In

Hot
Out

Hot

In

Hot
Out

Warnings!

High Voltage present inside the controller. If you need to reach inside the controller
disconnect power first.

This product shoud be used to adjust the light intensity on incandescent light bulbs
only. Hired Hand is not liable for any problems that may arise from use with other
lighting systems.

Tools Required

Screwdriver

Cordless Drill

Wire Strippers

Installation

1. Hang the Manual Light Dimmer using the four

screws provided.

2. Make sure all power supplies are disconnected

before breaking any wires.

3. Open the Manual Light Dimmer, and find all

connections. See fig. 1

4. Connect all wires using the wiring diagram in

fig. 1 below.

5. Re-connect power.
6. Installation complete.

J2

J3

J9

J8

J7

J4

J6

J5

J10

J11

J12

C2

TR1

R1

R3

R6

R4

R2

R5

R8

R7

5k

C1

TR3

MBS4991

TR4

MBS4991

TR2

GND

Hot
In

Hot
Out

Hot
In

Hot
Out

Branch 1

Branch 1

Branch 2

Branch 2

Center

ON

Control

Control

Copyright (c) 1998, '99

Copyright (c) 1998, '99
Hired-Hand, Inc

Hired-Hand, Inc

Farmhand Manual Light Dimmer

Farmhand Manual Light Dimmer

Pcb 150 rev 'A'

Pcb 150 rev 'A'

HIRED-HAND INC.

1733 Co Rd Bremen, AL 35033

Phone 256-287-1000

Fax 256-287-2000

Manual Part No. 4801-5040 rev 11-05

Branch

1

Branch

1

Branch

2

Branch

2

Hot (120vac)

Hot (120vac)

Neutral

Neutral

Lights

Earth Ground

Fig. 1

Operation

1. To place full power on incandescent light blubs,

place switch to

position. See fig. 2

2. To turn incandescent light blubs off,

place switch to

positon.

See fig. 2

3. To adjust light intensity, place switch to

position, adjust the lights using the

knob in the center. See fig. 2

On

Off

Variable

Fig. 2

4501-5071

Manual Light

Dimmer

Variable

Variable

On

(prendido)

(prendido)

Electrical shock may occur if the enclosure is opened
with power connected to the unit. Wiring and connections must comply
with all national and local electrical codes. Installation by qualified
electrician required!

On

Circuit 1

Circuit 2

Off

Off

Off

Off

3

2

1

4

5

6

7

8

9

10

Warning!

(circuito 1)

(variable)

(variable)

(circuito 2)

Knob

(Variable Adjust)

Lights

O

N

O

F

F

20

O

N

O

F

F

20

20 Amp

20 Amp

Breaker

Box

Ratings and Specifications

Room Temp: 122 F / 50°C Maximum
Input :

120 VAC 50/60 Hz

Output:

4800 Watts, 40 Amps Maximum

Per Circuit: 2400 Watts, 20 Amps Maximum

*Circuits Should Be Fused @ 20 Amps Max.

°

HIRED-HAND

Circuits Should Be Protected With A

Breaker Rated At 20 Amps Maximum.

IMPORTANT