Hired-Hand Mega-Cool: In-Line Pump Motor Replacement User Manual
Megacool in-line pump motor, Replacement, Warning

HIRED-HAND MFG., INC.
• 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 265-287-2000
Manual Part Number 4802-5115 Rev. 2-06 Page 1 of 2
WARNING
Disconnect all Electrical Power before installing the Mega Cool Pump Motor.
TOOLS REQUIRED PART NUMBERS
INSTRUCTIONS
Remove the Pump and Strainer
Assembly from the Mega-Cool System by
disconnecting the two Pipe Couplings. See
Figure 1. Your Pump arrangement may
appear different from that shown in Figure 1.
Remove the Strainer from the Pump
Assembly by rotating the strainer coupling
counter clockwise. Check the condition of the
strainer gasket and save for re-installation
later. See Figures 2 and 3.
!
Large Flat Head
Screwdriver
1/4" Driver
Socket Set
Mega-Cool Pump Motor Replacement
Part
Number
Quan. Description
3017-6100
1
MTR Emer 3/4hp 230v 60hz Replacement Motor
IMPORTANT!
Locate packing slip and make sure that all listed parts are enclosed. If not, call your Hired-Hand distributor
immediately. Please read and understand all instructions in this manual before installing pump.
MegaCool In-Line Pump Motor
Replacement
Figure 1 Remove Pump and Strainer Assembly
Coupling
Coupling
STEP 1
STEP 2
Rotate Strainer
Coupling Counter
Clockwise
Figure 2 In-Line Pump & Strainer
Figure 3 Strainer Removed
Retain Strainer Gasket