C0 1, C1 1, C1 2 – Yokogawa Integral Oxygen Analyzer ZR202 User Manual
Page 75
<7. Startup>
7-10
IM 11M12A01-04E
Table 7.5
Minimum and Maximum Value Setting Procedure
Switch operation
Display
Description
>
∧
ENT
A
01
Display after the password has been entered.
>
∧
ENT
C
01
Set the oxygen concentration at 4 mA. Change the parameter code to C11.
Touch the [∧] key to switch to Group C.
>
∧
ENT
C
0
1
Touch the [>] key to move the position of the digit that is flashing to the right.
>
∧
ENT
C
1
1
Touch the [∧] key to enter the numeric value 1.
>
∧
ENT
0
00
Touch the [ENT] key to display the current set value (0% O
2
has been set).
>
∧
ENT
0
0
0
Touch the [>] key to move the position of the digit that is flashing to the right.
>
∧
ENT
0
1
0
Touch the [∧] key to change the numeric value to 1.
>
∧
ENT
010
If you touch the [ENT] key, all the digits flash.
>
∧
ENT
010
Touch the [ENT] key again to stop the flashing.
>
∧
ENT
C
11
Touch the [ENT] key once again, and the display will switch to the parameter code
selection display.
>
∧
ENT
C1
1
Set the oxygen concentration at 20 mA. Touch the [>] key to move the position of
the digit that is flashing to the right.
>
∧
ENT
C1
2
Touch the [∧] key to enter the numeric value 2.
>
∧
ENT
0
25
Touch the [ENT] key to display the current set value.
>
∧
ENT
025
Touch the [>] key to move the position of the digit that is flashing to the right.
>
∧
ENT
02
0
Touch the [∧] key to change the numeric value to 0. The numeric value will change
from 5 to 6 ... to 9 and back to 0.
>
∧
ENT
020
If you touch the [ENT] key, all the digits flash.
>
∧
ENT
020
Touch the [ENT] key again to stop the flashing.
>
∧
ENT
C
12
Touch the [ENT] key once again to switch to the parameter code selection display.
>
∧
ENT
Basic
panel
display
Touch the [>] key together with the [ENT] key to return to the basic panel display.
(This is not required if you proceed to make another setting.)(The displayed
numeric characters indicate the measurement gas concentration.)
The symbol [
] indicates that the key is being touched. Light characters indicates that the digits are flashing.