Lincoln Electric P709 GUARDIAN CONTROL SOLUTIONS - Manual (Page 51)

B-1 OPERATION
GUARDIAN CONTROL™ SOLUTIONS
B-1
SAFETY
GENERAL
Lincoln Electric does not accept any liability for dam-
age to the product or personal injury caused by failure
to follow the safety instructions in this manual, or by
improper installation, use, maintenance, and repair of
the product mentioned on the cover of this document
and any corresponding accessories.
Specific working conditions or accessories may require
additional safety instructions. Immediately contact your
supplier if you detect a potential danger when using the
product.
The user of the product is always fully responsible for
observing the local safety instructions and regulations.
Observe all applicable safety instructions and regula-
tions when installing, using or repairing this product.
User manual
• Everyone working on or with the system, must be
familiar with the contents of this manual and must
strictly observe the instructions. Management should
instruct the personnel in accordance with the manual
and observe all instructions and directions given.
• Never change the order of the steps to perform.
• Always keep the manual with the system.
Pictograms and instructions on the product (if pre-
sent)
• The pictograms, warning and instructions attached to
the products are part of the safety features. They
must not be covered or removed and must be present
and legible during the entire life of the product.
• Immediately replace or repair damaged or illegible
pictograms, warnings and instructions.
Users
• The use of this system is exclusively reserved to well
authorized, trained and qualified users. Temporary
personnel and personnel in training can only use the
product under close supervision and responsibility of
skilled engineers.
• The system is not to be used by children or persons
with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge.
INTENDED USE
The system has been designed exclusively for reduc-
ing the risk of filter fires. In the event of fire, it detects
and suppresses at an early stage, thus minimizing
damage. Using the system for other purposes is con-
sidered contrary to its intended use. The manufacturer
accepts no liability for any damage or injury resulting
from improper use. The product has been built in
accordance with state-of-the-art standards and recog-
nized safety regulations. Only use this system in accor-
dance with its intended use and the instructions
explained in the Installation Section of this manual.
Intended use is limited to fire risk and does not involve
explosion risk.
Technical Specifications
The specifications given in this installation manual
shall not be altered.
Modifications
Modification of this product is not authorized.
Product Combinations
Since the products are used in combination with other
products and machines, the safety instructions in the
documentation of those products also apply.
Follow the requirements of the
national fire protection association
(NFPA) and the local authorities hav-
ing jurisdiction.
-----------------------------------------------------------------------
WARNING
ELECTRIC SHOCK can kill.
• Turn off input power using the dis-
connect switch at the fuse box before
working on the equipment.
• Install equipment in accordance with the U.S.
National Electrical Code, all local codes and the
manufacturerʼs recommendations.
• Ground the equipment in accordance with the
U.S. National Electrical Code and the manufactur-
erʼs recommendations.
------------------------------------------------------------------------
MOVING PARTS can injure.
• Do not operate with doors open or
guards off.
• Stop motor before servicing.
• Keep away from moving parts.
------------------------------------------------------------------------
WARNING