Lincoln Electric P709 GUARDIAN CONTROL SOLUTIONS - Manual (Page 21)

A-14 INSTALLATION
GUARDIAN CONTROL™ SOLUTIONS
A-14
SAFETY PRECAUTIONS
• Service and Repair should only be performed by
Lincoln Electric Factory Trained Personnel.
• Electric connections should be executed in accor-
dance with local requirements. Ensure compliance
with the EMC regulatory arrangements.
• During installation, always use Personal Protective
Equipment (PPE) to avoid injury. This also applies to
persons who enter the work area during installation.
• Use sufficient climbing gear and safety guards when
working higher than 6 feet (local restrictions may
apply).
• Never install any product in front of entrances and
exits which must be used for emergency services.
• Do not move, puncture, cut or otherwise disturb any
gas, water pipes and/or electric cables.
• Make sure the wall, ceiling or support system is
strong enough to support the weight of the products
being mounted.
• Ensure the workspace is well illuminated.
• Use common sense. Stay alert and keep your atten-
tion to your work. Do not install the product when you
are under the influence of drugs, alcohol or medicine.
• Make sure that the installation location, contains suf-
ficient approved fire extinguishers.
• Install according to the National Fire Protection
Association (NFPA) requirements and the state
and local authorities having jurisdiction.
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or
electrode with skin or wet clothing.
• Insulate yourself from work and
ground
• Always wear dry insulating gloves.
------------------------------------------------------------------------
MOVING PARTS can injure.
• Do not operate with doors open or
guards off.
• Stop engine before servicing.
• Keep away from moving parts.
------------------------------------------------------------------------
TYPICAL INSTALLATION SEQUENCE
1. Mechanical installer shall install fan, filter, Spark
Guardian™, sliding valves and related interconnect-
ing ductwork. Also, mechanical installer shall set Oil
Guardian™ in place and route ductwork between Oil
Guardian™ and main duct.
2. Electrical installer shall install System Control
Panel and wire between System Control Panel, fan
and filter. Also, Electrical installer shall install
Guardian™ Panel.
3. Controls installer shall install all detectors and
shall wire all low voltage devices including: heat,
smoke and spark detectors, solenoid valve, sliding
valves, Flame Guardian™, fire alarm sounder and
manual call point and interconnect to System
Control Panel from Guardian™ Panel.
NOTE: DO NOT wire in Flame Guardian™ aerosol
until after system is fully tested.
TOOLS AND REQUIREMENTS
• Connection Wire: 5 x 20 AWG
• Connection Wire: 5 x 20 AWG Shielded Cable
• Electric Drill
• Self-tapping Screws (various sizes)
• Mounting Material Guardian™ Panel
• Metal Cable Glands/Clamps
• Duct Support Material (depending on weight of slid-
ing valves)
• Lifting And Climbing Gear
• Existing Duct: Angle Grinder Or Jigsaw
INSTALLATION AND COMMISSIONING
To avoid accidental fire alarms and the activation of
Flame Guardian™ fire extinguishing generator(s), the
following installation and commissioning sequence
shall be followed. Deviation from this sequence is
allowed, as long as the fire extinguishing generator
is/are the last item(s) to be connected; even after hav-
ing performed the functional tests.
1. Filter/fan installation
2. Spark Guardian™
3. Valves (sliding valves + solenoid valve)
4. Oil Guardian™
5. Flame Guardian™ fire extinguishing generators
(isolated)
6. System control panel
7. Guardian™ Panel (without power)
8. Detectors (heat, sparks, smoke)
See the full Commissioning Checklist for more infor-
mation.
FILTER/FAN
See Filter / Fan Instruction Manual for detailed
installation instructions.
WARNING