Installation, Spark guardian – Lincoln Electric P709 GUARDIAN CONTROL SOLUTIONS User Manual

Page 22

A-15

INSTALLATION

GUARDIAN CONTROL™ SOLUTIONS

A-15

SPARK GUARDIAN™

GENERAL DESCRIPTION

The Spark Guardian™ is a cyclonic Spark arrester that
provides excellent protection against sparks and ciga-
rette butts. Also it is an in-line pre-separator reducing
the dust load in the connected filtration system.

COMPONENTS

The product consists of the following main components
and elements:

See Figure A.4.

A. Inlet
B. Cyclone
C. Duct clamp
D. Outlet
E. Dustbin cover including connection flange and

hose

F. Dustbin

SAFETY

• Service and Repair should only be performed by

Lincoln Electric Factory Trained Personnel.

• Use sufficient climbing gear and safety guards when

working on a higher level than 6 feet (local restric-
tions may apply).

• Never install the product in front of entrances and

exits which must be used for emergency services.

• Make sure the wall, ceiling or support systems are

strong enough to support the weight of the product
being mounted.

INSTALLATION

Tools and requirements

See Table A.2 for necessary tools to mount the prod-
uct.

UNPACKING

Check that the product is complete. The package
should contain:

Spark Guardian™ 250/400/500 Components (See
Figure A.4)

• Spark Guardian™, consisting of inlet(A), Cyclone(B),

and outlet(D), connected by duct clamp(C)

• Dustbin 13 liters(F)

• Dustbin 27 liters(F)

• Dustbin cover incl. connection flange and hose(E)

For duct connection of Spark Guardian™: (See
Figure A.8)

• Connection ring (2) Ø 250/400/500 mm(A)

• Duct clamp (2) Ø 250/400/500 mm(B)

For connection of vertical duct Ø 200 mm between
Spark Guardian™ and dustbin: (See Figure A.10)

• Connection ring (2) Ø 200 mm(A)

• Duct clamp Ø 200 mm(B)

FIGURE A.4 – SPARK GUARDIAN™ COMPO-

NENTS

B C

TABLE A.2

Duct >1 m Ø 200 mm/

8 inch (recommended)

Lifting and climbing

gear; e.g.

• Sling

• Fork-lift truck and pallet

• Scissor lift

Box spanner (or wrench):

• SparkShield-250/10:

M10 + M13

• SparkShield-400/16:

M10 + M13

• SparkShield-500/20:

M10 + M13 + M16

Electric drill + self-
tapping screws

Existing duct:

• Angle grinder; or

• Jigsaw + electric drill

Duct support material