C.3 setup procedure for linux, Figure c-21: press any key to continue, C .3 s etup p rocedure for l inux – IEI Integration KINO-PV-D4253_D5253 User Manual

Page 118

P age 106

K INO-P V-D5253-D4253 Mini-ITX Motherboard

The recovery tool main menu window is shown as below. Press any key to reboot the

system.

Figure C-21: Press Any Key to Continue

C .3 S etup P rocedure for L inux

The initial setup procedures for Linux system are mostly the same with the procedure for

Microsoft Windows. Please follow the steps below to setup recovery tool for Linux OS.

Hardware and BIOS setup. Refer to Section C.2.1.

Install Linux operating system. Make sure to install GRUB (v0.97 or earlier) MBR type

and Ext3 partition type. Leave enough space on the hard drive to create the

recover partition later.

NOTE:

If the Linux OS is not installed with GRUB (v0.97 or earlier) and Ext3,

the Symantec Ghost may not function properly.

While installing Linux OS, please create two partitions:

 Partition 1: /

 Partition 2: SWAP