IEI Integration PICOe-GM45A - Manual (Page 48)

PICOe-GM45A Half-Size CPU Card
Page 48
3.1 Anti-static Precautions
WARNING!
Failure to take ESD precautions during the installation of the
PICOe-GM45A may result in permanent damage to the PICOe-GM45A
and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the PICOe-GM45A. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the PICOe-GM45A, or any other electrical component is
handled, the following anti-static precautions are strictly adhered to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding:- Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: When configuring the PICOe-GM45A, place it on an
antic-static pad. This reduces the possibility of ESD damaging the
PICOe-GM45A.
Only handle the edges of the PCB:- When handling the PCB, hold the PCB
by the edges.
3.2 Unpacking
3.2.1 Unpacking Precautions
When the PICOe-GM45A is unpacked, please do the following:
Follow the anti-static precautions outlined in Section
763H724H
3.1.
Make sure the packing box is facing upwards so the PICOe-GM45A does not
fall out of the box.
Make sure all the components shown in Section
764H725H
3.3 are present.