Teledyne LeCroy Merlin Mobile - Users Manual - Manual (Page 80)

72
Merlin Mobile User’s Manual CATC SW Version 2.0
in the Modes tab in the Recording Options dialog box.
Step 3 Run "Passive Sync and Record." The Master will then page the
slave’s address and Merlin Mobile will be able to sync.
Step 4
When Merlin Mobile synchronizes to the Master, turn the slave back
on. When the Master re-pages the address the slave is admitted into
the private network. Since Merlin Mobile is passive in this mode,
the slave and Merlin Mobile do not conflict over the shared address.
Merlin Mobile is then able to record the traffic between the Master
and slave.
Page Sync & Record
"Page Sync and Record" is the recommended method of recording. "Page
Sync and Record" should be implemented before a piconet is established.
This mode causes Merlin Mobile to perform a General Inquiry and collect
sync information from the specified slave device when it responds. Merlin
Mobile then waits for the Master to begin paging the Slave devices. When
paging begins, Merlin Mobile synchronizes to the Master and begins
recording.
Note In order for this mode to work, the intended Slave must support "inquiry scan".
The following steps describe the simplest way to use this mode:
Step 1
Place both the "intended master" as well as its first "intended slave"
into inquiry scan mode.
Step 2
Have Merlin Mobile perform a General Inquiry. You do this by
pressing the BT Neighborhood button
Step 3
After the General Inquiry completes, the addresses will populate the
menus marked Master Device and Page Target. Select or enter the
addresses for both your Master Device and Page Target.
Step 4
Click OK at the bottom of the window to close the Recording
Options dialog box.
Step 5
Press the button found on Merlin Mobile's
toolbar. After approximately 20 seconds, the "SYNC" light
on the front of Merlin Mobile will begin to flash, meaning
that Merlin Mobile has acquired all the information it needs
to fully synchronize with the piconet about to be established.
At this point, you should establish the piconet using the
devices previously defined as master and slave.
Note Inquiry Timeout is configurable (0 to 80 seconds) in the Recording Options
General page.