Teledyne LeCroy Merlin Mobile - Users Manual User Manual

Page 79

Merlin Mobile User’s Manual

CATC

SW Version 2.0

the Master device. When the piconet Master pages Merlin Mobile, Merlin
Mobile obtains the information necessary for synchronization and then
attempts to synchronize to the piconet controlled by that Master.

"Passive Sync and Record" is designed to be used with established piconets
or private device networks.

Running "Passive Sync and Record" with Established Piconets

For most situations, "Passive Sync and Record" will be run after a piconet
has been established. The steps are as follows:

Step 1

Establish a connection between two or more Bluetooth devices.

Step 2

Under General Recording Options, select "Passive Sync & Record."

Step 3

Under the Modes tab in Recording Options, enter the address for the
piconet’s master device.

Step 4

Make up an address for Merlin Mobile and enter it into the Page
Target address in the Modes tab in Recording Options. Make sure
you do not select an address for any other local device.

Step 5

Press the record button on the toolbar in Merlin
Mobile to start a recording session.

Step 6

If necessary, have Master "discover" Merlin Mobile through a
General Inquiry.

Step 7

From the Master device, initiate a page to Merlin Mobile’s address.
This action will enable Merlin Mobile to synchronize to the piconet.
However, the analyzer will not complete the page sequence from the
Master. This will cause the Master to time out in this request.

Step 8

At the end of this sequence, the green Sync light will go on solid,
recording will begin and activity will be displayed on the status bar
in the bottom of the analyzer screen.

Running "Passive Sync and Record" with Private Device Piconets

Because private device networks do not allow other devices to join the
network, Merlin Mobile needs to temporarily assume the identity of a slave
in the network in order to join that network. To do this requires disabling the
slave and beginning the operation without an established piconet. The
following steps show the process.

Step 1

Turn the Master device on and the slave device off. You need the
slave device turned off so that Merlin Mobile can take its place in the
piconet.

Step 2

Enter the slave’s address into Merlin Mobile’s "Page Target" field