Teledyne LeCroy Merlin Mobile - Users Manual - Manual (Page 37)

29
Merlin Mobile User’s Manual CATC SW Version 2.0
6 A trigger event occurred, and the analyzer is recording the traffic of the piconet
with the master device that has BD_Address 00837163787. However, no
triggering occurred.
7 Analyzer is performing a BT Neighborhood action, where it makes inquiries
for Bluetooth devices.
8 Merlin application uploads recorded data from the analyzer at the end of a
recording session.
As recording progresses, the Progress Indicator changes to reflect the
recording progress graphically:
• In the Progress Indicator, a black vertical line illustrates the location of the
Trigger Position you selected in Recording Options.
— Pre-Trigger progress is displayed in the field to the left of the Trigger
Position in the before-Trigger color specified in the Display Options.
— When the Trigger Position is reached, the progress indicator wiggles as it
waits for the trigger.
— After the trigger occurs, the field to the right of the Trigger Position fills
in the post-Trigger color specified in the Display Options.
— When recording is complete, the upper half of the progress indicator fills
in white, indicating the progress of the data upload to the host computer.
You should be aware of two exceptional conditions:
• If a Trigger Event occurs during the before-Trigger recording, the
before-Trigger color changes to the after-Trigger color to indicate that not all
the expected data was recorded pre-Trigger.
• When you click Stop before or after a Trigger Event, the Progress Bar adjusts
accordingly to begin uploading the most recently recorded data.
The Progress Bar fills with color in proportion to the specified size and
actual rate at which the hardware is writing and reading the recording
memory. However, the Progress Indicator is normalized to fill the space
within the Status Bar.
Recording Status
During recording activity, the current Recording Status is temporarily
displayed in the next segment. When you activate the Record function, this
segment flashes one of the following messages (depending on the selected
Recording Options):
— Trigger?
— Triggered!
— Uploading
After recording stops,