Teledyne LeCroy Merlin Mobile - Users Manual - Manual (Page 38)

30
Merlin Mobile User’s Manual CATC SW Version 2.0
— The flashing message changes to Uploading data–x% done (x%
indicates the percentage completion of the data uploading process).
— The traffic data is copied to disk (overwriting any previous version of this
file) using the default file name data.tfb or a new name specified in the
Recording options.
To abort the upload process,
Click in the Tool Bar.
You are prompted to choose whether to keep the partially uploaded data or to
throw it away.
When the data is saved, the Recorded Data file appears in the main display
window and the Recording Status window is cleared.
• If the recording resulted from a Trigger Event, the first packet following the
Trigger (or the packet that caused the Trigger) is initially positioned second
from the top of the display.
• If the recording did not result from a Trigger Event, the display begins with the
first packet in the traffic file.
Analyzer Status
The third segment in the status bar displays analyzer status. The status will
display one of the following:
No Sync - the system is not synced to any piconet
Inquiring... - The system is performing an Bluetooth Inquiry
Syncing to [XXX]... -- The system is attempting to synchronize to a piconet
where the device with BD_Address XXX is the master.
Synced to [XXX] - The system is synchronized to a piconet where the
device with BD_Address XXX is the master.
Recording [XXX] - system is recording the Bluetooth traffic of the piconet
where the device with BD_Address XXX is the master.
After the analyzer has synchronized to the Bluetooth piconet under
observation, the Status Bar will display activity bars and the strength (in
dBm) of the radio signal that Merlin is receiving. The activity bars will
increase or decrease with activity. The signal strength readings will display
as five possible values:
• below -60 dBm
• - 60 dBm
• - 50 dBm
• - 40 dBm