Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 70)

WaveAce Remote Control
WAVEFORM TRANSFER – WAVEFORM SETUP, WFSU
The WAVEFORM_SETUP command specifies the amount of data in a waveform to be transmitted to
the controller. This is defined by the parameters: Sparsing, interval between data points; Number of
Points, total number of points to be transmitted; First Point, the address of the first data point to be
sent; Segment Number, which segment to be sent if the waveform was acquired in sequence mode.
The WAVEFORM_SETUP? query returns the transfer parameters currently in use.
Command Syntax
WaveForm_SetUp SP,,NP,,FP,point>,SN,
:= 0 to n where 0 sends all data points
n sends every nth data point
:= 0 to n where 0 sends all data points n
sends a maximum of n data points.
:= 0 to n where 0 sends the first data point
n sends n+1.
:= 0 to n where 0 sends all segments
n sends the nth segment.
NOTE: After power-on, all values are set to 0 (i.e., entire waveforms will be transmitted without sparsing).
Query Syntax
WaveForm_SetUp?
Response Format
WaveForm_SetUp SP,,NP,,FP,,SN,
Example
The following command specifies that every 3rd data point (SP=3) starting at address 200 (FP=200) in segment
23 (SN=23) should be transferred:
WFSU SP,3,FP,200,SN,23
Related Commands
WAVEFORM
68 920836 Rev B