Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 43)

Operator's Manual
Parameter Definition
MAX Maximum value
MEAN Mean value
MIN Minimum value
NDUTY - Duty cycle
NWID Negative width (negative edge to positive edge)
OVSN Overshoot negative/FOV
OVSP Overshoot positive/ROV
PER Period
PKPK Peak to peak
PWID Positive width (positive edge to negative edge)
RISE Rise time 10% to 90%
RMS Root mean square
RPRE Rising edge preshoot
TOP Top
WID Width
Response Format
:PArameter_VAlue ,,...
:=
A decimal numeric value
:= {OK, AV, PT, IV, NP, GT, LT, OF, UF, OU}
NOTE: If is not specified, or is equal to ALL, all standard voltage and time parameters are returned
followed by their values and states. When PAVA? Is used to query a Custom parameter, the prefix is
returned for consistency. The source for the measurement is configured using the PACU command.
Example
The following instruction query reads the rise time of Trace B (TB):
TB:PAVA? RISE
Response message:
TB:PAVA RISE,3.6E-9S,OK
Related Commands
CURSOR_MEASURE, CURSOR_SET, PARAMETER_CUSTOM
920836 Rev B 41