Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 17)

Operator's Manual
Commands and Queries by Name (Alphabetical)
Short Form Long Form What the Command/Query Does
*CAL? *CAL?
Performs a complete internal calibration.
*CLS *CLS
Clears all status registers.
*ESE *ESE Sets the standard Event Status Enable register (ESE).
*ESR? *ESR? Reads, clears the Event Status Register (ESR).
*IDN? *IDN? Returns device identification data.
*OPC *OPC
Sets the OPC bit in the Event Status Register (ESR).
*RST *RST
Initiates a device reset.
*SAV *SAV Stores current state in internal memory.
*TRG *TRG Executes an ARM command.
ACAL AUTO_CALIBRATE
Performs periodic calibration of instrument. Supported only on
WaveAce 2000 series.
ACQW ACQUIRE_WAY
Specifies the acquisition mode.
ALST? ALL_STATUS? Reads and clears the contents of all status registers.
ARM ARM_ACQUISITION Changes acquisition state from stopped to single.
ASET AUTO_SETUP Adjusts vertical, timebase and trigger parameters.
ATTN ATTENUATION
Selects the vertical attenuation factor of the probe.
BUZZ BUZZER
Controls the buzzer in the instrument.
BWL BANDWIDTH_LIMIT Enables/disables bandwidth-limiting low-pass filter.
CHDR COMM_HEADER Controls formatting of query responses.
CMR? CMR? Reads, clears the CoMmand error Register (CMR).
CPL COUPLING
Selects the specified input channel's coupling mode.
CRMS CURSOR_MEASURE Specifies the type of cursor/parameter measurement.
CRST CURSOR_SET Allows positioning of any cursor.
CRVA? CURSOR_VALUE? Returns trace values measured by specified cursors.
DDR? DDR? Reads, clears the Device Dependent Register (DDR).
DEF DEFINE
Specifies mathematical function to perform.
DIR DIRCTORY Creates or deletes file directories on mass storage devices.
DTJN DOT_JOIN Controls the interpolation lines between data points.
EXR? EXR? Reads, clears the EXecution error Register (EXR).
FLNM FILENAME
Changes default filename of traces, setups and hard copies.
FRTR FORCE_TRIGGER
Forces the instrument to make one acquisition.
HMAG HOR_MAGNIFY Horizontally expands the expanded trace.
HPOS HOR_POSITION Horizontally positions intensified zone's center.
ILVD INTERLEAVED Enables/disables Random Interleaved Sampling (RIS).
INR? INR? Reads, clears INternal state change Register (INR).
920836 Rev B 15