Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 18)

WaveAce Remote Control
Short Form Long Form What the Command/Query Does
INTS INTENSITY Controls the brightness of the grid.
OFST OFFSET Allows output channel vertical offset adjustment.
PACU PARAMETER_CUSTOM
Controls parameters with customizable qualifiers.
PAVA? PARAMETER_VALUE? Returns current parameter, mask test values.
PDET PEAK_DETECTED Enables or disables built-in peak detection function.
PERS PERSIST Enables or disables the persistence display mode.
PESU PERSIST_SETUP Selects display persistence duration.
RCPN RECALL_PANEL
Recalls a front panel setup from mass storage.
SCSV SCREEN_SAVE Enables or disables the screen saver.
STO STORE Stores a trace in internal memory or mass storage.
STOP STOP Immediately stops signal acquisition.
TDIV TIME_DIV
Modifies the timebase setting.
TRA TRACE
Enables or disables the display of a trace.
TRCP TRIG_COUPLING Sets the coupling mode of the specified trigger source.
TRDL TRIG_DELAY Sets the time at which the trigger is to occur.
TRLV TRIG_LEVEL
Adjusts the trigger level of the specified trigger source.
TRMD TRIG_MODE
Specifies the trigger mode.
TRSE TRIG_SELECT Selects the condition that will trigger acquisition.
TRSL TRIG_SLOPE Sets the trigger slope of the specified trigger source.
VDIV VOLT_DIV Sets the vertical sensitivity.
WAIT WAIT
Prevents new analysis until current is completed.
WF WAVEFORM
Transfers a waveform from controller to scope.
WFSU WAVEFORM_SETUP Specifies amount of waveform data to go to controller.
16 920836 Rev B