Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 59)

Operator's Manual
STATUS - *CLS
The *CLS command clears all status data registers.
Command Syntax
*CLS
Related Commands
ALL_STATUS, CMR, DDR, *ESR, EXR, *STB
STATUS - *ESE
The *ESE command sets the value of the ESB bit in the Event Status Enable register (ESE). The *ESE?
query reads the contents of the ESE register.
Command Syntax
*ESE
:= 0 to 255
Query Syntax
*ESE?
Response Format
*ESE
Example
The following allows the ESB bit to be set if a user request (URQ bit 6, decimal 64) and/or a device
dependent error (DDE bit 3, decimal 8) occurs. Summing these values yields the ESE register mask
64+8=72.
*ESE 72
Related Commands
*ESR?
920836 Rev B 57