Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 46)

WaveAce Remote Control
DISPLAY - HOR_POSITION, HPOS
The HOR_POSITION command repositions the geometric center of a zoom to display different portions
of the trace. Allowed positions range from division 0 through 10. If the source trace was acquired in
sequence mode, the shift will only apply to a single segment at a time.
The difference between the specified and the current horizontal position is applied to all zooms.
However, if the difference would cause any zoom trace to go outside the left or right screen
boundaries, the difference is adapted before being applied to the traces.
The HOR_POSITION? query returns the position of the geometric center of the zoom.
NOTE: Segment number 0 has the special meaning Show All Segments Unexpanded.
Command Syntax
Hor_POSition ,
:= 0 to 10 DIV
:= 0 to max segments
NOTE: The segment number is only relevant for waveforms acquired in sequence mode; it is ignored in single
waveform acquisitions. When the segment number is set to 0, all segments are shown. The unit DIV is optional.
Query Syntax
Hor_POSition?
Response Format
Hor_POSition [,]
Example
The following instruction positions the center of the zoom at division 3:
HPOS 3
44 920836 Rev B