Cursor - cursor_measure, crms, Command syntax, Query syntax – Teledyne LeCroy WaveAce 1000_2000 Remote Control User Manual

Page 37: Response format, Example, Related commands

Operator's Manual

CURSOR - CURSOR_MEASURE, CRMS

The CURSOR_MEASURE command specifies the type of cursor or parameter measurement to be

displayed, and is the main command for displaying parameters and Pass/Fail. Use it to turn on/off

cursors.
The CURSOR_MEASURE? query indicates which cursors or parameter measurements are currently

displayed.

Command Syntax

CuRsor_MeaSure

:= {HREL, VREL}

Where:

HREL

- Horizontal relative cursors.

VREL

- Vertical relative cursors.

Query Syntax

CuRsor_MeaSure?

Response Format

CuRsor_MeaSure

Example

The following instruction switches on the vertical relative cursors:

CRMS VREL

Related Commands

CURSOR_SET, PARAMETER_VALUE,

920836 Rev B