Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 52)

WaveAce Remote Control
MISCELLANEOUS – AUTO-CALIBRATE, ACAL
Available only on WaveAce 2000 models, AUTO_CALIBRATE enables or disables automatic calibration
of the oscilloscope. If ACAL is ON at power-up, all input channels are periodically calibrated for the
current input amplifier and timebase settings, whether the instrument has been adjusted or not. This
is separate from the calibration the instrument performs whenever you adjust a gain or offset.
ACAL OFF disables Auto-calibration. You can issue a *CAL? query at any time to fully calibrate the
oscilloscope, but periodic calibrations stop if ACAL is OFF.
The response to the AUTO_CALIBRATE? query indicates whether auto-calibration is enabled or
disabled.
Command Syntax
Auto_CALibrate
:= {ON, OFF}
Query Syntax
Auto_CALibrate?
Response Format
Auto_CALibrate
Related Commands
*CAL?
MISCELLANEOUS - BUZZER, BUZZ
The buzzer command controls the built-in buzzer. By means of the BEEP argument, the buzzer can be
activated to sound short beeps at key points in the control program.
Command Syntax
BUZZer
:= {ON, OFF}
Example
The following instruction turns off the buzzer:
BUZZ OFF
50 920836 Rev B