beautypg.com

Display - trace, tra, Command syntax, Query syntax – Teledyne LeCroy WaveAce 1000_2000 Remote Control User Manual

Page 50: Response format, Example

background image

WaveAce Remote Control

DISPLAY - TRACE, TRA

The TRACE command enables or disables the display of a trace. An environment error is set if an

attempt is made to display more than four waveforms. Refer to the table in STATUS - EXR? (on page

63) for more information.
The TRACE? query indicates whether or not the specified trace is displayed.

Command Syntax

:TRAce

:= {C1,C2,C3,C4,TA,TB,TC,TD}

:= {ON, OFF}

Query Syntax

:TRAce?

Response Format

:TRAce

Example

The following instruction displays Trace C1:

C1:TRA ON

48

920836 Rev B

See also other documents in the category Teledyne LeCroy Equipment: