Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 68)

WaveAce Remote Control
WAVEFORM TRANSFER - STORE, STO
The STORE command stores the contents of the selected trace.
Command Syntax
STOre [,]
:= {TA,TB,TC,TD,C1,C2,C3,C4,ALL_DISPLAYED}
:= {M1,M2,M3,M4,M5,M6,M7,M8,M9,M10,FILE}
Example
The following instruction stores the contents of Trace A (TA) into Memory 1 (M1):
STO TA,M1
The following instruction stores all currently displayed waveforms onto the memory card:
STO ALL_DISPLAYED,FILE
The following instruction executes the storage operation currently defined in the Storage Setup:
STO
WAVEFORM TRANSFER - WAVEFORM, WF
The WAVEFORM command transfers a waveform from the controller to the oscilloscope. The
WAVEFORM? query reads a waveform from the oscilloscope to the controller.
WAVEFORM stores an external waveform back into the oscilloscope's internal memory. A waveform
consists of several distinct entities:
• DESC - The descriptor
• TEXT - The user text
• TIME - The time descriptor
• DAT1 - The data block
and, optionally...
• DAT2 - A second block of data
NOTE: Only complete waveforms queried with WAVEFORM? ALL can be restored to the oscilloscope.
The WAVEFORM? query instructs the oscilloscope to transmit a waveform to the controller. The
entities can be queried independently. When the ALL parameter is specified, all four or five entities are
transmitted in one block in the order listed above.
66 920836 Rev B