Teledyne LeCroy WaveAce 1000_2000 Remote Control - Manual (Page 38)

WaveAce Remote Control
CURSOR - CURSOR_SET, CRST
The CURSOR_SET command allows you to position any one of the independent cursors at a given grid
location. When you are setting a cursor position, you must specify an active trace relative to which the
cursor is positioned.
The CURSOR_SET? query retrieves the current position of the cursor(s). The values returned depend on
the grid type selected:
HREF Horizontal Cursor A VREF Vertical Cursor A.
HDIF Horizontal Cursor B VDIF Vertical Cursor B.
Command Syntax
:CuRsor_SeT ,,...
:= {TA,TB,TC,TD,C1,C2,C3,C4,M1,M2,M3,M4,M5,M6,M7,M8,M9,M10}
:= {HABS, VABS, HREF, HDIF, VREF, VDIF}
:= 0 to 10 DIV (horizontal);-3.99 to 3.99 DIV (vertical)
Query Syntax
:CuRsor_SeT?
:= {HREF, HDIF, VREF, VDIF}
No implies ALL, even though not all are visible.
Response Format
:CuRsor_SeT ,,...,
If the position of a cursor cannot be determined, its position will be given as
UNDEF
.
Example
The following instruction positions the VREF and VDIF cursors at +3 DIV and -2 DIV respectively, using
Trace TA as a reference:
TA:CRST VREF,3DIV,VDIF,-2DIV
Related Commands
CURSOR_MEASURE, CURSOR_VALUE?, PARAMETER_VALUE?
36 920836 Rev B