LevelOne GSW-4876 - Manual (Page 259)

C HAPTER 5 | Monitoring the Switch
Showing IGMP Snooping Information
– 259 –
S HOWING IGMP S NOOPING I NFORMATION
Use the IGMP Snooping pages to display IGMP snooping statistics, port
members of each service group, and information on source-specific groups.
S HOWING IGMP
S NOOPING S TATUS
Use the IGMP Snooping Status page to display IGMP querier status,
snooping statistics for each VLAN carrying IGMP traffic, and the ports
connected to an upstream multicast router/switch.
P ATH
Monitor, IPMC, IGMP Snooping, Status
P ARAMETERS
These parameters are displayed:
Statistics
◆ VLAN ID – VLAN Identifier.
◆ Querier Version – IGMP version used by the switch when serving as
the IGMP querier.
◆ Host Version – IGMP version used when used by this switch when
serving as a host in IGMP proxy mode.
◆ Querier Status – Shows the Querier status as “ACTIVE” or “IDLE.”
When enabled, the switch can serve as the Querier, which is responsible
for asking hosts if they want to receive multicast traffic.
◆ Querier Transmitted – The number of transmitted Querier messages.
◆ Querier Received – The number of received Querier messages.
◆ V1 Reports Received – The number of received IGMP Version 1
reports.
◆ V2 Reports Received – The number of received IGMP Version 2
reports.
◆ V3 Reports Received – The number of received IGMP Version 3
reports.
◆ V2 Leaves Received – The number of received IGMP Version 2 leave
reports.
Router Port
◆ Port – Port Identifier.
◆ Status – Ports connected to multicast routers may be dynamically
discovered by this switch or statically assigned to an interface on this
switch.