LevelOne GSW-4876 - Manual (Page 104)

C HAPTER 4 | Configuring the Switch
Configuring Security
– 104 –
opcode flag set, Reply - frame must have ARP Reply or RARP Reply
opcode flag; Default: Any)
■
Sender IP Filter - Specifies the sender’s IP address.
(Options: Any - no sender IP filter is specified, Host - specifies the
sender IP address in the SIP Address field, Network - specifies the
sender IP address and sender IP mask in the SIP Address and SIP
Mask fields; Default: Any)
■
Target IP Filter - Specifies the destination IP address.
(Options: Any - no target IP filter is specified, Host - specifies the
target IP address in the Target IP Address field, Network - specifies
the target IP address and target IP mask in the Target IP Address
and Target IP Mask fields; Default: Any)
■
ARP Sender MAC Match - Specifies whether frames can be
matched according to their sender hardware address (SHA) field
settings. (0ptions: Any - any value is allowed, 0 - ARP frames where
SHA is not equal to the SMAC address, 1 - ARP frames where SHA is
equal to the SMAC address; Default: Any)
■
RARP Target MAC Match - Specifies whether frames can be
matched according to their target hardware address (THA) field
settings. (Options: Any - any value is allowed, 0 - RARP frames
where THA is not equal to the DMAC address, 1 - RARP frames
where THA is equal to the DMAC address; Default: Any)
■
IP/Ethernet Length - Specifies whether frames can be matched
according to their ARP/RARP hardware address length (HLN) and
protocol address length (PLN) settings. (Options: Any - any value is
allowed, 0 - ARP/RARP frames where the HLN is equal to Ethernet
(0x06) and the (PLN) is equal to IPv4 (0x04) must not match this
entry, 1 - ARP/RARP frames where the HLN is equal to Ethernet
(0x06) and the (PLN) is equal to IPv4 (0x04) must match this
entry; Default: Any)
■
IP - Specifies whether frames can be matched according to their
ARP/RARP hardware address space (HRD) settings. (Options: Any -
any value is allowed, 0 - ARP/RARP frames where the HRD is equal
to Ethernet (1) must not match this entry, 1 - ARP/RARP frames
where the HRD is equal to Ethernet (1) must match this entry;
Default: Any)
■
Ethernet - Specifies whether frames can be matched according to
their ARP/RARP protocol address space (PRO) settings.
(Options: Any - any value is allowed, 0 - ARP/RARP frames where
the PRO is equal to IP (0x800) must not match this entry, 1 - ARP/
RARP frames where the PRO is equal to IP (0x800) must match this
entry; Default: Any)