LevelOne FCS-9900 - Manual (Page 75)

75
Map Window
Adjusting Map Appearance
The display of map graphics in the Map window can be controlled. The size of the map can be selected, and the map
moved in the window to show the required area. The brightness of the map graphic can also be changed without affecting
the brightness of device indicators on the map.
To control the size of a map:
Use the zoom in / zoom out buttons or with the mouse wheel to adjust map size, or click the magnify button
and select one of the following options:
 Full Size
 Fit Image
 Fit Width
 Fit Height
To enable area zoom:
Click the magnify button and then select Area Zoom. Click and drag with your mouse to draw a rectangle on the map.
This area will be magnified to fit the screen. Click again to turn Area Zoom off.
When Area Zoom is enabled, click on the map to center it. Drag the minimized icon on the lower right corner to move the
map around.
To lock the map size:
Click the magnify button and then select Zoom Lock. This prevents the accidental changing of the map size. To turn
Zoom Lock off, click it again.
To pan when the map size is larger than the Map window:
Click and drag the map to the position you want.
To lock the map pan setting:
Click the magnify button and then select Pan Lock. This prevents accidental panning of the map. To turn Pan Lock off,
click it again.
The controls above can also be accessed on the Zoom menu.
To adjust map brightness:
Move the brightness slider for the brightness you want.
Navigating Between Map and Servers/ Devices
It is easy to navigate between different layers of maps, and to show the maps for devices in various locations. There are
two ways of doing this: clicking icons in MapView, and using indicators on the map.
To navigate in MapView:
Ensure that the MapView window is selected. Then either:
 Click the icon for the map you want to display.