IAI America RCA2-SD4N User Manual
Page 59
8. Installation
51
8.3
Short Types (Tapped-hole mounting types)
RP3NA, RP3N (Lead screw, ball screw), RP4NA, RP4N (Lead screw, ball
screw)
8.3.1 Installation of Actuator
Install the actuator by guiding it through a hole of approx. 5 to 10 mm provided in a smooth plate.
• Use the tapped hole on the actuator to install the actuator onto the actuator mounting plate.
• The base of the male thread on the actuator side has a tolerance of h8. Use this part as a pilot
section.
Actuator mounting plate
Actuator
Ɣ RP3N (Lead screw, ball screw)
Tapped
mounting hole