Ronan X96S DENSITY GAGE - Manual (Page 59)

Density Gage Manual 012407 55
Detector Removal/
Replacement
ELONGATED DETECTORS NOTES:
To avoid damage in shipment or installation, the
elongated detectors are packaged separate from the
housing. Avoid subjecting detectors to mechanical
shock. Avoid supporting detector by its chain handle,
or other lifting devices, for prolonged periods of time.
When detector is properly seated on the bottom of the
housing, the hold-down clamp “tab” will engage and
the extension rod screw can be adjusted to tighten
detector assembly into housing.
DETECTOR HOUSING/
BRACKET ASSEMBLY NOTES:
Many detectors are shipped inside the housing/bracket
assembly. Bolts at the top and bottom of the C-Clamp
are used to adjust the assembly around a pipe.
1) Check NOTES below for illustrations and cautions
that apply to your specific equipment.
2) Unscrew cap on detector housing.
3) Unscrew connector on top of detector.
4) Remove detector from housing.
5) Carefully install replacement detector in housing.
6) Screw connector back onto detector.
7) Immediately replace detector-housing cap.
8) Follow instruction to REFERENCE or
CALIBRATE new detector.
Detector Housing
Cap
Detector Housing
Cable Connector
Detector