Ronan X96S DENSITY GAGE - Manual (Page 32)

Density Gage Manual 012407 28
Calibrate Menu
This menu is used to access the various calibration procedures. It contains the following items:
ITEM FUNCTION
Low Reference Selecting this takes the user to the Low Reference menu
High Calibrate Selecting this takes the user to the High Calibrate menu
Manual Entry Shows and allows the user to set the density slope value
Clear Ref/Cal This invokes a method that clears the density reference
Temp Ref This invokes a method that performs the process temperature calibration
Pressure Ref This invokes a method that performs the process pressure calibration
Auto Reference Selecting this takes the user to the Auto Reference menu
Low Reference Menu
This menu is used to perform the low reference procedure. It contains the following items:
ITEM FUNCTION
Reference This invokes a method that performs the low reference procedure
Ref Density Shows and allows the user to set the reference density value
Ref Cap Shows the raw captured density counts
High Calibrate Menu
This menu is used to perform the high calibrate procedure. It contains the following items:
ITEM FUNCTION
Calibrate This invokes a method that performs the high calibrate procedure
Cal Density Shows and allows the user to set, the calibrate density value
Cal Cap Shows the raw captured density counts
1/uT Shows the calculated slope value (Same value as in Calibrate Menu, Manual Entry)
Temp Reference Menu
(This menu is ONLY used if the Hardware Menu, Proc Temp value is set for 0-10 volts or 4-20 ma.)
This menu is used to perform the process temperature reference procedure. It contains the following items:
ITEM FUNCTION
Temp LoRef This invokes a method that performs the low temp reference
Temp HighCal This invokes a method that performs the high temp calibration
Temp Cal Low Temperature value during the Temp Lo Ref procedure
Temp Cal High Temperature value during the Temp High Cal procedure
Temp Cap Low Shows the raw captured temperature counts during the low temp reference
Temp Cap High Shows the raw captured temperature counts during the high temp calibration
RTD Slope Factory value for RTD Slope
RTD Offset Factory value for RTD Offset