Ronan X96S DENSITY GAGE - Manual (Page 26)

Density Gage Manual 012407 22
Source Type Menu
The Source Type menu is used to define the type of radiation source used. It contains the following items:
ITEM FUNCTION
Source Type Shows and allows the user to set the source type
Usr Def Source Selecting this takes the user to the Usr Def Source menu
Next Reference Shows the date of when the next Reference should be completed
Next Wipe Test Shows the date of when the next Wipe Test should be completed
Next Shutter
Test
Shows the date of when the next Shutter Test should be completed
Source Type is one of the following:
ITEM MEANING
Unknown Source type not known
co_60 Cobalt 60
cs_137 Cesium 137
am_241 Americium 241
Usr Def Any source type other than the ones listed above OR a source of the nominal type
listed above with a different half-life
Usr Def Source Menu
The Usr Def Source menu is used to define the type of radiation source used. It contains the following items:
ITEM FUNCTION
Name Shows, and allows the user to set, the source type name
Half Life Shows, and allows the user to set, the source half life
Pressure is one of the following:
ITEM MEANING
None No pressure measurement device configured
0-10 volts Pressure measurement device that provides a 0 to 10 volt signal
4-20 ma Pressure measurement device that provides a 4-20 ma signal
Analog Out Config
The analog Out Config menu is used to set where the source of power is. It contains the following items:
ITEM FUNCTION
Loop 1 Shows and allows the user to assign a source to Loop 1
Loop 2 Shows and allows the user to assign a source to Loop2
Loop 3 Shows and allows the user to assign a source to Loop 3
Power Source Shows and allows the user to set whether the source of power is internal or
external, to power the AO modules outputs
Loops 1-3 contain the following selections:
ITEM FUNCTION
X96S-2005 Selecting this will assign the HART card to the desired loop
X96S-2004, chan 1 Selecting this will allow the user to assign channel 1 to the desired loop
X96S-2004, chan 2 Selecting this will allow the user to assign channel 2 to the desired loop
None No card selected