beautypg.com

Rfid reader setup, continued – Fairbanks AN Series Fairbanks Access Solutions User Manual

Page 97

background image

Section 3: Access Terminal Screens Defined

01/13

97

51299 Rev. 1

3.3.5. Rfid Reader Setup, Continued

Network Connection

Host: Enter the host name or the IP address of the device or the serial to Ethernet
converter that is connected serial to the device.

Port: Specify the TCP port number that the data is being sent from the host. See
documentation or configuration of the host for this information.

Configure Device: Click on this link to open the host in a web browser.

Remote Connection

Enable: If this terminal is not directly using the device but instead just acting as a
serial to Ethernet converter, then enable this option. In this case the other terminal
would use the IP address of this terminal as the host name and the port number
specified.

Port: Specify the TCP port on the terminal to provide device data on.

Allow Local Use: Enabling this will allow this terminal and another terminal to both
control the device. Normally if a remote connection is being use this terminal does
not use the RFID reader. This is only available for certain RFID readers.