Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 96)

Section 3: Access Terminal Screens Defined
01/13 96 51299 Rev. 1
3.3.5. Rfid Reader Setup, Continued
Initialization Commands: To allow customization of the Transcore reader, various
commands can be sent to the reader to initialize it. The terminal will put the reader at
factory defaults. Then additional commands can be sent to modify its behavior as
necessary. Default commands are: 474 to read tags on the 2110 reader and 300,
310 to disable axillary information from the 1620 reader.
Reinitialize: Use this button to reinitialize the reader after making changes.
Show More/Less: Use this button to show more or show less initialization
commands.
Manual Commands: Use this area to send a command directly to the reader. Enter
the command number and a timeout value. If no timeout value is entered, the default
will be used. Refer to the Transcore reader's manual for details on commands to
send.
Command Response: This are will display the response from the reader for that
command.
Serial Connection
Serial COM Port: Select the serial port that the device is connected to.
Baud Rate: Select the baud rate for the serial communications with the device.
Parity: Select the parity setting for the serial communications: N - none, O - odd, E -
even, S - space, M - mark.
Data Bits: Number of data bits in the serial communications.
Stop Bits: Number of stop bits in the serial communications.