Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 39)

Section 3: Access Terminal Screens Defined
01/13 39 51299 Rev. 1
3.2.7. Matrex Setup,Continued
SERVER CONNECTION
•
Server Label: Distinguish between server connections.
•
Description: Additional information about server connection.
•
Server Name: Name or IP address of the MatreX server; once functioning, DO
NOT change setting. It is always recommended to use the name of the server
instead of the IP address.
•
HTTP Address: Allows user to install MatreX in a different location of
processing server (non default website). Once functioning, DO NOT change
setting.
•
Server URL: Shows full web address the unit connects to.
•
Use Type: (previously located on Access Terminal Setup)
see Section. 3.1.3.1. ACCESS UNIT SETUP
•
Company Number: The serial number of the Access Terminal. This should be
set to match the serial number on the label located inside the Access unit. This
number can affect communications with MatreX and the ability to back up and
restore.
ADVANCED SETTINGS
•
HTTP Verb: DEFAULT IS POST Allows for different types of HTTP request,
do not change unless also changed in the MatreX server settings.
•
HTTP Port: DEFAULT PORT IS 80
•
Read Buffer Size: DEFAULT 1024
•
Network Timeout: Value used to communicate with MatreX processing
server. Calls typically fail prior to value.
•
Network Attempts: Attempts to connect to the MatreX server before failing.
•
Retry Interval: Delay between each retry attempt.