Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 53)

Section 3: Access Terminal Screens Defined
01/13 53 51299 Rev. 1
3.2.11. Traffic Control Setup, Continued
Gate: Select an output that will
be connected to a gate. Also
specify how long to keep the
output on.
Close gate: When enabled, the Access terminal will close the gate when the
selected input is detected. The input should be a sensor near the gate that will detect
the vehicle. The duration time is then used to make sure the gate is open for at least
the specified number of seconds. It also keeps the gate open until the vehicle is
detected by the sensors near the gate.
Sign: This is a sign (configured
on the Device Setup menu),
that will direct the vehicle onto
and off of the scale.
Display: This is a remote
display (configured on the
Device Setup menu), that will
direct the vehicle onto and off
of the scale.
Exit only: When enabled, the
exit only option on the sign or
display will change the device
to only direct a vehicle off of the
scale.
Staging Sign: This is a sign
(configured on the Device
Setup menu) located in the
staging area that will indicator
to any waiting drivers that the
scale is available to be used.
Staging Input: Associated with a sensor (usually a ground loop) that will detect a
vehicle in the stage area. A latching time can also be applied to the input. This is
often necessary and should be set based on the distance from the sensor to the
scale. The longer the distance the longer the latch time should be.